Roland PC-200 Bedienungsanleitung Seite 11

IF YOUR PC-200 FAILS
Make sure that the 6 Alkaline Batteries (MN 1500) are not below their charge limits.
Also check that the Batteries make good contact with the holder.
* When using the AC Adaptor, make sure that the AC Adaptor cord is firmly plugged into the sock-
et [101 on the rear panel. Make sure that the AC cord of the ADAPTOR is firmly plugged into
the AC wall outlet.
* Also check that the AC wall outlet is not faulty. Plug in a lamp or radio to test the wall outlet.
* Be sure the ON/OFF switch [9] (located on the rear panel) is ON.
In the event the instrument is still inoperable, your Roland technician or dealer is best qualified
to provide you with competentservice.Do not attempt any adjustmentsor repairs by yourself.
DEFAULT SETTING
The PC-2()O will always select the following features, when it is turned on (theseare often called Default
settings):
DATA ENTRY is enabled to modify the Volume.
— Midi Channel no. 1 transmitted
— Program change no. 1 transmitted when the ENTER key is pressed (see MIDI Controls)
— DEFAULT OCTAVE will be from C 2 (36) to C 6 (84).
TO OPERATE
11