Roland PC-200 Bedienungsanleitung Seite 10

PROGRAM CHANGE SELECTION
It is possible to send Program
Press the MIDI/SELECT
bled, as it is programming.
— Press one of the following keys [6] to select:
program change 0
program change 1
— program change 2
program change 3
4 = program change 4
program change 5
program change 6
4 = program change 7
program change 8
program change 9
CANCEL
ENTER
After selecting a program
Example:
To send program change no. 125 press C 4 (1), C# 4 (2), E 4 (5) keys in sequence, then press A # 4
(ENTER).
Whenever the A #4 (ENTER) key is pressed, the last program change selected will be sent.
When the instrument is turned on (default setting), pressing A # 4 (ENTER) without digiting any other
number, the program change no. 1 will always be sent.
If a program change number is digited by mistake, press A 4 (CANCEL) key to cancel the operation,
then perform the correct procedure again.
Press the MIDI/SELECT
board is enabled to play again.
MIDl CONTROL
M.I.D.I. is the acronym for Musical Instrument
MIDI is a standardized interface by which all digital musical instruments also equipped with MIDI con-
nections can exchange data. This means that your PC-200 can be used as a MIDI control keyboard -
to control other MIDI devices (synthesizers, expanders, computers etc.).
There is one MIDI «OUT» socket [Ill
external MIDI devices.
change numbers from 1 to 127.
[2] button, the corresponding led will light. Now the keyboard will be disa-
change number, press the ENTER
button once more, the corresponding led will be turned off and the key-
Digital Interface.
on the rear panel of the PC„200 to send MIDI messages to control
10
button (A #4) to send it.