Information & Service; Troubleshooting Guide - Philips HB556 Benutzerhandbuch

Problem
Solarium does not switch on.
The power fuse switches the mains
power off when switching on or while
using the solarium.
The browning is not according to your
expectations.
Information & service
If you need information or if you have a problem, please visit the Philips
Web site at www.philips.com or contact the Philips Customer Care
Centre in your country (you will find its phone number in the
worldwide guarantee leaflet). If there is no Customer Care Centre in
your country, turn to your local Philips dealer or contact the Service
Department of Philips Domestic Appliances and Personal Care BV.

Troubleshooting guide

If the solarium should not operate as required, this may be due to a
defect. In this case do not hesitate to apply to your dealer or to a
Customer Care Centre.
However, it is also possible that the appliance has not been installed
according to the instructions or is used incorrectly.
If this is the case, you will be able to solve the problem immediately.
You may check the following section before contacting your dealer or
Customer Care Centre.
Possible cause
Mains plug is not in wall socket.
No mains power. (Please check with other appliance.)
Timer has not been set.
The lamp of the face tanner (HB 556 only) is still too warm to restart. (Allow
the lamp to cool down for approx. 3 minutes)
Check the fuse to which the solarium has been connected.
The proper type for your solarium is a 13 A (for U.K.) or a 10 or 16 A (for
other countries) normal fuse or a slow reacting automatic fuse.
You followed a course which is not the most appropriate for your skin type.
The operational distance is larger than indicated.
After using for a long time the UV production of the lamps decreases. (With
normal use this will not be noticeable for years.)
You may compensate for this effect by selecting longer treatment times or
replace the sun lamps
ENGLISH
17