ANSMANN JUMPSTARTER 10.0 Bedienungsanleitung Seite 12

TROUBLESHOOTING
Problem Possible cause
Jump
starter Voltage of jump starter
does not too low
switch on
• Voltage of jump
starter too low
Jump star- • Negative and positive
ter does poles reversed
not work
• Temperature
outside the specified
temperature range
• Overload protection
All LEDs • Appliance too warm/
are cold
flashing
• Ambient temperature
too high/low
‫ ׉‬ENVIRONMENTAL INFORMATION | DISPOSAL
Dispose of packaging after sorting by material type.
Cardboard and cardboard to the waste paper, film to the
recycling collection.
Dispose of the unusable product in accordance with legal
provisions. The "waste bin" symbol indicates that, in the
EU, it is not permitted to dispose of electrical equipment in
household waste.
For disposal, pass the product on to a specialist disposal
point for old equipment, use the return and collection
systems in your area or contact the dealer from whom you
purchased the product.
Batteries and rechargeable batteries contained in
electrical appliances must be disposed of separately
whenever possible.
22
Solution
Charge the battery/
jump starter
• Charge the battery/
jump starter
• Connect terminals
correctly
• Attempt to restart
within the appro-
priate temperature
range
• Switch off appliance
and check
• Maintain temperature
from +5C° to +40C°
• Maintain ambient
temperature from -15
C° to +40C°
Always dispose of used batteries & rechargeable batteries
(only when discharged) in accordance with the local
regulations and requirements.
Improper disposal may result in toxic ingredients being
released into the environment, which may have adverse
health effects on humans, animals and plants.
In this way you will fulfil your legal obligations and
contribute to environmental protection.
‫ ׉‬LIABILITY DISCLAIMER
The information contained within these operating
instructions can be changed without prior notification.
We accept no liability for direct, indirect, incidental or
other damage or consequential damage arising though
improper handling/use or through disregard of the
information contained within these operating instructions.
Subject to technical changes. We assume no liability
for printing errors.
23