ANSMANN JUMPSTARTER 10.0 Bedienungsanleitung Seite 10

CARE AND MAINTENANCE
circle-c
Carry out cleaning tasks only when the mains plug has
been pulled out / when the power supply has been
disconnected.
Clean only with a slightly damp cloth, then rub it dry.
Do not use abrasive agents or solvents for cleaning.
Allow the product to cool down completely before
cleaning.
Do not allow fluids to enter the housing.
Do not use hard brushes or sharp objects for cleaning.
DEVICE DESCRIPTION (SEE ILLUSTRATION)
1. Jump starter cable connection socket
2. USB-A output 1: 5V / 2.4A
3. USB-A output 2: 5V / 2.4A
4. LED lamp
5. On/off button for lamp / USB outputs / battery capacity
indicator
6. Display of the remaining battery capacity
7. Type-C charging socket
PROPER INTENDED USE
The product is intended for use as a jump starter for 12 V
vehicle batteries, for charging mobile appliances that have
a 5 V USB input, and as a work light.
The jump starter can be used to restart a vehicle with a
12 V battery. It is suitable for starting diesel and petrol
engines. The integrated USB output can also be used to
charge mobile devices such as tablets or smartphones.
Includes LED work light with continuous light, strobe and
SOS function.Please note before starting:
• Only the jump leads may be connected to the jump
starter during a jump start. It is not possible to supply
another appliance via the USB port and must be
disconnected beforehand.
• The jump start specifications in the vehicle's
operator's manual must be observed. Failure to
observe the specifications can result in damage to
the vehicle.
• Switch off all current collectors such as headlamps
18
and radio on the vehicle.
• Never attempt to start a vehicle without the starter
battery connected.
• Ensure that the plug of the jump leads is firmly
connected to the appliance socket. If the connection
is loose during the jump-start process, the plug
connection may melt due to the high current.
• Ensure that the terminals of the jump leads are firmly
attached to the battery terminals and that the t
erminals of the vehicle battery are clean.
• Warning! Never connect the terminals of the jump
leads when the 'Boost' button is pressed and during
the jump-start process – short circuit with sparking
possible, risk of explosion.
• The jump starter should have at least 75% battery
capacity so that there is sufficient power for a
successful start attempt.
• The storage temperature must be within the range of
+ 5 °C...+ 40 °C.
• The ambient temperature during the jump-start
process must be within the range of – 15 °C...+ 40 °C.
• Only use the supplied jump leads with the pole
terminals.
Please note during use:
• Connect the terminals firmly to the battery terminals.
• Stow the jump starter securely in the engine
compartment so that it cannot fall during the starting
process.
• The jump starter and the connecting leads must not
be within reach of moving parts.
• Pressing the 'Boost' button overrides the safety
devices integrated in the jump starter. Therefore,
always connect the jump starter to the battery first
and then press the 'Boost' button.
FIRST USE
1. Slide open the cover of the jump lead connection and
connect the jump leads to the jump starter.
2. First connect the red lead to the positive terminal and
then the black lead to the negative terminal of the
vehicle battery.
19