Hama SCORPAD PRO Bedienungsanleitung Seite 6

'V. Installation PS3
1. Switch on the controller on the rear of the right grip
2. Connectthe controller's receiver to your console's
USB connector.
3. After you pressthe controller's MODEbutton, the
controller automatically connects to the receiver via
the autoscan function
4. If no connection can be made, disconnect the receiver
andpress Selectandthe L3buttononthe controller at
the sametime.(TheL3buttonis belowthe right
analoguestick).
5. Connectthe receiver to the console again
6. Press the MODE button again —the connection is now
established, andthe PS3console assignsthe control
ler a port (1to 4).
V. Functions
Turbo button
If you activate the turbo function for a button, the button's
function is triggered repeatedly at short intervals as long
as it is pressed.
To assign the turbo function to a button, first press the
Turbo button and then the button to which
is to be assigned.Repeatthe process(pressTurbo
andthen the assignedbutton) to deactivate the turbo
function
Mode button
The Mode button on the controller correspondsto the
PS buttonon the Sony PS3controller. Pressthis button
for 2 seconds to go to the PS3XMB window.
6
Motion
The controller is equipped with Sixmotion technology,
which provides you with motion-sensitive control and
allows you to perform movements in supported games.
Vibration
The »SCORPAD PRO" controller is equipped with two
internal motors, which function only in games that also
support Force Feedback.
Refer to your game's manual orto the Sony website to
find out if your game supports the vibration function
If problems persist, check whether vibration support has
been activated in the game's options.
Note: In order to support vibration, the PS3 console's
firmware must be updated to version 2.0
Sleep mode
TO extend the battery's service life and to save energy,
the controller has a sleep mode, which places the
controller
a)after 55 seconds if no receiver is in range
the function
b)after 5 minutesif a receiver is in range but no games
are being played
Towake the controller out of hibernation,press the
MODE button.
sensors
function
in hibernation: