Nuface MINI+ Benutzerhandbuch Seite 7

T EC H I N CA L I N FO R M AT I O N ( C O N T I N U E D )
as cellular phones, two-way radios, cordless phones, etc. not be located within 10 feet/ 3m of the
Mini+ during treatment. The NuFACE® Mini+ complies with the requirements of IEC 60601-1-2:2014
for Radiated and Conducted Emissions in Group 1 Class B.
The NuFACE® Mini+ complies with the requirements of IEC 60601-1-2:2014 for Harmonic distortion
in Harmonic classification A.
The NuFACE® Mini+ incorporates Bluetooth® low energy communications at 2.4 GHz frequency
single-ended RF with -20 to +4 dBm Effective Radiated power.
Max Current: 335uA RMS
Max Unloaded Voltage: 28VDC
FC C C O M P L I A N C E
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
—Consult the dealer or an experienced radio/TV technician for help.
—Changes or modifications not expressly approved by NuFACE could void your authority to
operate the equipment.
Industry Canada Compliance
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada's license-exempt RSS(s). Operation is subject to the
following two conditions: 1. This device may not cause interference. 2. This device must accept any
interference, including interference that may cause undesired operation of the device.
CAN ICES-3 (B) / NMB-3 (B) This Class B digital apparatus complies with Canadian ICES-003.
10
NF_RestageMini_UserManual_Global75117_051722.indd 10-11 NF_RestageMini_UserManual_Global75117_051722.indd 10-11
REF
20400 FCC ID: 2AGNA-20400
Conforms to EN IEC/UL: Device - 60529, 60335-1, 60335-2-23, 60601-1, 60601-1-11, 60601-1-2,
60601-1-6, 60601-2-10, 62133-2, 62366-1
Power Supply - 60950-1, 60068-2-70
SYM BOL S
One or more of the following markings may appear on Mini+ Device, User Manual or packaging.
European Conformity
European Representative
REF Part Number
Operator's Manual;
Operating Instructions
Refer to Instruction Manual/Booklet
Manufacturer
Detachable Power Supply Part
Power On/Off
IP52 Protection against dust particles: Protected against vertically falling water drops when
enclosure is tilted up to 15°.
Type BF applied part, which is equipment that provides a particular degree of protection
against electric shock. Particularly regarding allowable leakage current and of the
protective earth connection.
IC: 25861-20400
Comply with European Restriction of
Hazardous Substances Directive 2002/95/EC
Product must be disposed of in accordance
with the WEEE directive
FCC-approved equipment authorization mark
Class II double insulated electrical device
5/17/22 12:47 PM 5/17/22 12:47 PM
11