Philips GoZero ADD4902 Gebrauchsanleitung Seite 9

Best before: see the date
Do not breathe the gas contained
and valve integrity.
Remove the carbonating
It is forbidden to remove
Always keep the cylinder
ventilated place. It is forbidden
A high concentration
when heated (H280).
Do not put the cylinder
from the body
Do not use the content
Do not alter and/or
Keep away from children.
DO NOT attempt to puncture,
DO NOT transport
The use duration of the cylinder
3 General
Product overview
Refer to
Machine rating
Maximum Working Pressure:
Maximum Allowed Operating
4 Before creating
Installing the gas cylinder
1. Place the Philips soda maker
bottle before installing
then carefully lay the soda maker
2. Remove seal and cap from the C02 cylinder.
bottom. Don't drop
screwing the cylinder
threads holding the gas cylinder
3. When you need to replace
counterclockwise
indicated on the cap or on the head
into the cylinder.
bottle if it is filled
and/or handle
away from any sources
to expose
can cause asphyxiation
Liquid contact may cause
into the freezer
for babies' food
modify the cylinder
throw or burn
the soda maker with
depends
description
of information:
116 psi/ 8 bar
Temperature:
fun
in an upright
or replacing the cylinder
down
the cylinder into the hole. When
clockwise until
in place
the gas cylinder,
and then carefully pull it out of the compartment.
It is forbidden
with water before
the cylinder while
of heat and direct
the cylinder to temperatures
(EIGA-As). t contains
freezing burns.
and/or into the fridge.
preparation
and the valve,
the cylinder.
the cylinder attached,
on the use frequency.
40 oc / 1040F
position and on a flat
if it is filled
on the side.
Carefully insert the cylinder
you feel that it reaches
it is fastened. Don't
A2-l
lay the soda maker
sleeve, or at the bottom
to alter and/or
installing the cylinder.
the soda maker is working.
sunlight, keep in a cool and
higher than
gas under pressure;
f frozen do not use it and keep it away
surface. Remove
with water. Remove
through the hole at the
the bottom,
screw too hard since
down on the side
A 2-2
of the cylinder.
modify the cylinder
500C.
it may explode
the carbonating
the drip tray grid and
begin
this might break the
and unscrew it