Safety Instructions; Installation - Saro Merle Dig Betriebsanleitung

• Keep these operating instructions within easy reach near the unit.
•
The manufacturer/dealer cannot be held responsible for damage caused by failure to observe these operating
instructions.
• If these operating instructions are not observed, the safety of the unit can no longer be guaranteed.
•
If the unit is passed on to third parties, these operating instructions must also be handed over.
• This appliance must not be operated by children or persons with limited physical, sensory or mental abilities, as they
may not understand the hazards involved in the use of electrical appliances, resulting in accidents, fire, explosion or
property damage.
•
After unpacking the unit, make sure that everything is in perfect condition. If you discover any damage, do not connect
the unit but notify your dealer.
• Check whether all components specified in the scope of delivery are present. If this is not the case, inform your dealer.
• Keep the packaging of the unit. The unit can only be transported safely in its original packaging, e.g. for repair
purposes, when moving house, etc. Note that all components of the packaging (plastic bags, cardboard, polystyrene
parts, etc.) can endanger children and must therefore not be stored near them.
•
If it is not possible to store the packaging, separate the different packaging materials and deliver them to the nearest
collection point for proper disposal.
•
Do not use the unit outdoors in the rain or in damp rooms.
• Do not operate the unit unattended.
•
Observe the accident prevention regulations and general safety regulations applicable in your area.
• Place the unit in a dry, adequately ventilated place and on a straight, safe surface.
•
Before connecting the appliance to the mains and before using it, clean it carefully as indicated under "Cleaning".
• Before connecting the appliance, make sure that a shockproof socket (with earth) and a 230 volt connection are
available and that they correspond to the information on the type plate. Other types of current than specified on the type
plate may cause the appliance to overheat or become defective.
•
Do not drill or pierce holes in the inside or outside of the unit. The circuit could be damaged
• The manufacturer/dealer cannot be held responsible for damage caused by failure to observe the operating
instructions. Likewise, the safety of the unit is no longer guaranteed.
• In the event of a malfunction, disconnect the appliance from the mains and inform your dealer. He will carry out the
repair with original spare parts.

SAFETY INSTRUCTIONS

• Incorrect operation and improper handling can lead to malfunctions of the unit and injury to the user.
• Observe the accident prevention regulations and general safety regulations applicable in your area.
•
Ensure that the unit stands securely on a dry, non-slip surface that is adequate for the weight of the unit and that it is in
a well-ventilated place.
•
Before connecting to your mains, check that the type of current and mains voltage correspond to the information on the
type plate. Commissioning is only possible if they match in order to avoid accidents/defects.
•
Do not use adapters, power strips and/or extension cords; otherwise the cables/cords can quickly overheat if other
appliances are also connected. The risk of fire increases.
•
Do not move the appliance during use.
• Before moving the unit, switch it off (if there is a switch for this purpose) and disconnect the mains plug.
•
Always pull the cable out of the socket by the plug housing only.
• Do not let the mains cable hang over sharp edges, do not crush it and keep it away from hot objects and open flames.
• Make sure that it is not possible to accidentally pull on the cable or trip over it.
•
Check the cable regularly. If it is damaged, e.g. by crushing, then it must be replaced by a qualified specialist.
• Do not touch the appliance, cable or plug with wet or damp hands.
•
Caution! The unit is live as long as it is connected to the mains.
• Protect the unit from moisture.
•
Do not clean the appliance with an open jet of water.
• Do not immerse the unit in water or other liquids or wet it with liquids.
If the appliance should get wet, unplug it from the mains immediately and have it checked by a specialist before using it
again. There is a danger to life from electric shock.
•
A damaged unit must not be used!
In this case, disconnect the unit from the mains and contact your specialist dealer!
•
Repairs must be carried out by appropriate specialists using the original spare parts.
• Always disconnect the appliance from the mains before cleaning, and also if it is not going to be used for a long time.
•
For hygienic reasons, at least daily cleaning is recommended, but also in the course of a day if necessary.

INSTALLATION

Stand 11/24 SvN
Seite 14 von 19