cecotec TOOTHCARE JET SPLASH Bedienungsanleitung Seite 53

Filling up the water tank
Make sure that the appliance is switched off before adding water to the tank.
Fig. 2
1. Remove the water inlet plug by pulling it upwards and fill the tank.
2. You can also fill the water tank by removing it from the main body. To do this, pull the
water tank downwards to remove it, fill the water tank under the tap and replace it.
Fitting the nozzle
Fig. 3
Insert the nozzle into the nozzle hole. You will hear it click into place if correctly installed.
Turn the nozzle to set the water outlet direction.
To remove the nozzle, press the release button and pull it upwards.
Selecting modes
Fig. 4
You can select the mode of use from the 3 available before switching on the appliance. To do
this, press the mode change button repeatedly. The indicator light for each mode will light up
for 5 seconds.
The top light corresponds to the gentle mode.
-
The central light corresponds to the normal mode.
-
The bottom light corresponds to the DIY mode.
-
Note: the DIY mode pressure can only be adjusted when the irrigator is switched on.
You can also change the mode while using the irrigator by repeatedly pressing the mode
change button.
Setting the water pressure in the DIY mode
With the appliance switched on and the DIY mode selected, press and hold the mode change
button for 1 second. The DIY mode indicator light will flash. Release the button, the irrigator
will change the pressure between the 8 available levels. It will hold each level for 1 second
and move on to the next level; when it reaches level 8, it will start the cycle again. When the
irrigator is at the desired pressure level, press the mode change button once to select the
desired mode, the DIY mode indicator light will return to steady.
The irrigator will save this level as the default for DIY mode until you manually change it again.
Using the irrigator
1. Fill the water tank and insert a nozzle into the irrigator.
2. Select the desired mode and insert the irrigator nozzle into your mouth.
NOTE: when using the appliance for the first time, start with the Gentle mode or DIY mode at
its lowest level. Water pressure can increase gradually as your mouth adapts to it. You may
experience itching or slight bleeding of the gums during use. This is normal and it should
disappear after 1-2 weeks of continuous use.
ENGLISH
TOOTHCARE JET SPLASH
53