Trouble Shooting - Parkside Performance Pphsa 40-Li B2 Originalbetriebsanleitung

GB MT

Trouble Shooting

Problem Possible cause
Battery (15) discharged
Appliance­
Battery (15) not inserted
won't start
Safety switch (
pressed­properly
On/Off switch (7) defective
Internal­loose­contact
Intermittent­
operation
On/Off switch (7) defective
Knife­bar­(2) is blunt
Knife­bar­
Knife­bar­(2)­is­notched
becomes hot
Too much friction due to lack of
lubrication
Too much friction due to miss-
ing lubrication
Knife­bar­(2)­dirty
Bad trim
Knife­bar­(2)­blunt
Bad cutting technique
42
Corrective action
Recharge­battery­(Observe­the­operat-
ing instructions for the rechargeable
battery and charger)
Insert­battery­(Observe­the­operating­
instructions for the rechargeable bat-
tery and charger)
17) not
Turn­on­(see­"Operation")
Send­in­to­Service­Centre­for­repair
Send­in­to­Service­Centre­for­repair
Have­the­Knife­bar­sharpened­or­re-
placed­(Service­Centre)
Have­the­Knife­bar checked or re-
placed­(Service­Centre)
Oil the knife bar (2)
Lubricate knife bar (2)
Clean knife bar
Grind­or­have­knife­bar­replaced­
(Service Centre)
See ("Working with the hedge trimmer")