LENCO PDR-033 Bedienungsanleitung Seite 8

Adjusting the volume
Use the volume control on the right side of the device. The volume bar will appear on the display.
The volume range is from 0 to 20
Changing the device language
1. Long press MODE to open the system menu.
2. Use the volume control or ≤/≥ until Language is shown and confirm with OK.
3. Use the volume control or ≤/≥ until your desired language is shown and confirm with OK.
Setting saved will appear briefly on the display which then reverts back to the previously selected
mode.
Note: If you don't press any button in about 10 seconds, the display will revert back to the previously
selected menu option. (The settings that are not confirmed by pressing the OK button, will not be
stored.) To quit the menu, short press the MODE button or wait 10 seconds.
Changing the operating mode
1. Short press the MODE button repeatedly to switch between the digital radio (DAB+), FM radio,
AUX and Bluetooth mode.
2. Press OK to confirm the highlighted selection, or wait a few seconds until the device
automatically enters the selected mode.
DAB radio mode
Tuning
Switching to DAB mode will automatically play the previously selected station.
1. Short press ≤/≥ to open the full list of stations.
2. Use ≤/≥ to select the desired station and confirm with OK.
Note: You will also find the complete list of stations in the menu (long press the mode button) by
selecting Station List.
In this same menu you can also initiate a full channel scan by selecting Scan and press OK
⚫
If you want to select a specific frequency/frequency block, select Manual Tune.
The signal strength of the chosen frequency block will be shown as bars on the display.
There are no setting options available in this screen. Press OK, then MODE to quit the system menu.
Not all stations are on the air at all times; It could be that some stations have disappeared, or you
have received stations in another region that you can no longer receive in your new location: To clean
up the station list, you can remove these stations in the system menu with Prune Invalid.
8