Kettler HOI RIDE START Computeranleitung Seite 28

During exercise, in SCAN state, SPEED and RPM switch every 5 seconds. Press the MODE
key to switch the display and turn on or off the SCAN function. Process: SCAN → (RPM or
SPEED) → (SPEED or RPM) → SCAN
3. Exercise parameter settings
In standby mode, press the MODE key, and the value of the parameter to be set will flash.
At this time, press the UP or DOWN key to set it. After the setting is completed, you can
pedal to start exercise or press MODE to confirm and enter the setting of the next target
exercise parameter. TIME, DISTANCE, CAL, and PULSE can be set in sequence.
When a parameter is set and movement is started, the movement parameter will count
down. When the set motion parameter counts down to 0, the parameter will flash and the
buzzer will prompt. If a target heart rate is set and the current heart rate reaches or ex-
ceeds the set target heart rate value, the current heart rate value will flash as a reminder.
28