E-TS730EX.book 18 ページ 2005年11月11日 金曜日 午前10時10分
Programmable Settings
Programming via direct commands
You can program features using "direct commands"– special codes that take you directly
to the feature you wish to programme and allow you to select the desired setting. There is
no need to scroll through the unit's sub-menus.
Details of each feature can be found on the corresponding pages.
Important:
L Before programming, make sure the unit is not being used.
1
Press {
} ({F2} key).
2
Press {#}.
Feature Code?
:
3
Enter the desired feature code (see page 19).
4
Enter the desired setting code (see page 19).
5
Press {OK}.
6
Press {N} to exit programming mode.
Note:
L If the unit beeps 5 times, you entered an invalid code. Enter the correct code.
L If you make a mistake or enter the wrong code, press {C}.
L To exit programming, press {N} at any time.
L To go back to the previous menu, press {
18
} ({F1} key).