Hobs Installation - Whirlpool XBC 901 GH TC Gebrauchsanleitung

Hobs installation

Suitable precautions must be taken to ensure that the
installation is in compliance with current accident-prevention
regulations regarding electrical and gas connections.
For trouble-free operation of the appliance set into kitchen
units, the minimum distances indicated in fig.3 should be
complied with and the adjoining surfaces and rear wall should
be capable of withstanding a surface temperature of 65 °C.
Installation above a built-in oven
Both the electricity supply cable and the gas pipe must not
touch hot parts of the oven housing, in order to avoid
overheating.
Suitable air vents should be provided for as shown in fig.3
(inlet at least 200 cm² from the bottom, outlet at least 120
cm² from the top part) to allow adequate ventilation inside
the housing unit.
Fixing to the unit
To fix the hob to the unit, proceed as follows (fig.4);
• tighten 2 screws "A" (provided) into the unit, leaving the
screw heads projecting 1.5 mm from the wood;
• hook the hob onto the 2 screws "A" and push backwards;
• fix the hob to the unit at the rear using the 2 corner
brackets "B" and the 4 screws "C" provided.
C
B
12
A
fig.4
fig.3