Silvercrest STVD 45 A1 Kurzanleitung Seite 15

Ensure that the mains power cable can-
not be damaged by sharp edges or hot
points.
When using the device, ensure that the
mains power cable cannot be trapped
or crushed.
The device is not fully disconnected from
the power supply, even after it is
switched off. In order to fully disconnect
it, pull out the mains plug.
When removing the mains plug from the
wall socket, always pull on the plug and
never the cable.
Pull the mains plug out of the wall
socket, ...
... if there is a fault,
... when you are not using the device,
... before you clean the device and
... during thunderstorms.
To avoid any hazard, do not make mod-
ifications to the product.
During operation, completely unwind
the mains power cable, to prevent over-
heating and the cable from melting.
When using an extension cable, this
must correspond to the applicable safe-
ty regulations.
Never place the device on hot surfaces
(e.g. hot plates) or near to heat sources
or open fire.
Only use the original accessories.
Do not clean using sharp objects or
abrasive cleaning agents.
Assembling the device
Before the device can be switched on, the
base 18 must be assembled:
1. Figure A: put the back half of the
base 20 and the front half of the
base 21 together. Ensure that the con-
nection audibly clicks into place.
2. Pull the mains power cable 19 through
the opening in the middle of the
base 18.
3. Figure B: align the guide pin on the
underside of the tower fan 16 with the
hole in the base 18. Press the base
onto the tower fan. Ensure that the con-
nection audibly clicks into place.
4. Figure C: clamp the mains power ca-
ble 19 into the guide for the mains pow-
er cable 22.
5. Select a location which complies with the
safety information. Ensure that it is stable.
Remote control
The remote control 9 is supplied with a
CR2025 (3V) battery inserted. Before
switching on, remove the plastic strip from
the remote control.
13
GB