HEYLO BT 700 Bedienungsanleitung Seite 23

Bring the operating switch of the machine to the OFF position with the mains plug
plugged in. Then press all the following buttons at the same time for 4 seconds:
"HOUR" (4) , "SET % + (3) and "SET % - (2)" - the machine will the change to the
operating mode "Remote" and the "REMOTE"-LED lights up. Please note that the
machine functions without taking the remote control element into consideration if the
humidity setting is in the "Cont" (continuous) position.
ALARM RESET - resetting the alarm:
Bring the "POWER" (1) operating switch of the machine to the "OFF" position and the
press the buttons "HOUR" and SET % + (3) together for 10 seconds - all alarms have
now been reset.
Error display (Alarm) Overview, see Point 7
ATTENTION: Check whether the operating noise of the blower and compressor
is correct before leaving the unit unattended.
CAUTION: Check the building drier daily for proper operation. Protect floors
from any possible water flowing out. Empty the condensation container
regularly.
Turning off the device
To switch off set the operating switch (1) on the control panel to Off or O. The A
and D display will go off.
After drying is over read the operating hours counter and document the status if
possible.
After drying is over read the KW/h counter and document the status if possible.
Then the mains plug can be pulled out and the device can be transported away.
23 EN