Safety Instructions - HEYLO BT 700 Bedienungsanleitung

Building Dryer
BT 700

1. Safety instructions

Keep away from children: Do not let children play with the device or in its vicinity.
Electrical connection: HEYLO building driers are designed for operation at
230V/50Hz. Only use with a three-pin plug! Sockets used must be earthed or secured
with a residual current circuit breaker in the in-house installation system.
Protect power cables from damage: Never use the device with a damaged power
cable. If the power cable is damaged, it must be replaced by the same type of cable
with the same dimensions.
Extension cable: Only use permitted extension cables!
Handle with care: Do not let the device fall or throw it, since components or wiring
could otherwise get damaged.
Work on a stable surface: Always place the device on a stable, even surface.
Secure during transport: Secure device against slipping when transporting it in
vehicles.
Keep dry: Do not operate the device in puddles or stagnant water. Do not store or
operate outdoors. If the electrical wiring or device parts get wet, dry the device
thoroughly before re-using.
Keeping air vents open: Do not cover or block the air inlets and outlets.
Keep the filter clean: Always use a clean air filter. Do not let the filter get blocked
since the building drier could overheat. Make sure that no oil, grease or other kind of
dirt is suctioned into the building drier.
Repairing the device: Please only allow repairs to be carried out by HEYLO service
partners. You can obtain information on the HEYLO Service Centre or approved
service technicians by telephone, fax or E-mail.
Tel. +49 (0) 42 02 – 97 55 15
Fax +49 (0) 42 02 – 97 55 97
E-mail: service@heylo.de
18 EN