Optimum Time OE 14 Serie Bedienungsanleitung Seite 6

4. If you have the same problem getting a horse into the start box, but prefer COUNTIJP
minute beeps), then it is possible to use COUNTDOWN from a
WITHOUT the countdown alarms. it you ask the starter to tell you when 30 seconds remain and have
the timer programmed for 30 secorxis in countdown. the timer will beep at 3,2,1
The watch will therefore not need to be started while you get your horse into the start box. The minute
beeps will be automatic on countup.
5. The watch can be worn just like any normal watch on the wrist. It also has an elastic strap that means
the watch can be worn over clothing as well If the display is not convenient to look at when it is worn
like a normal watch. then the whole timer case can be tumed inside the outer clip to get a better
viewing angle.
6. If you prefer to have the watch top Ofthe hand, then the timer should be removed from the outer
clip and the elastic Strap removed from the outer clip The outer clip can then be sewed to a glove
using the 2 holes already in the clip. The timer can then be pushed back into the dip at whatever
angle is required.
WARNING
We always recommend that you try out the functions fully in practise and do not attempt to use the
watch for the first in a competition. This warning is for your own safety
COUNTUP OPTIONS
COUNTUP FROM ZERO (In countup
1. From CLOCK mode. press MODE once to access the first option of event timer. If the timer is
stopped and reset to 00:00, the display will show the word TMR and Down PLUS up arrows (If
the timer is running press the STOP button first and then press the CLEAR button), The display
will now show 00:00. Then press MODE again and the display will snow TMR and JUST the up
arrow. The lower digits will always snow 0:00 to show that was the set time
zero (with
ot less than minute
and then count up.
mode)
2 Press STARWSTOP and the timer will count up frorn zero in minutes and seconds to a maximum
ot 59mins 59secs.
3. During the countup, the timer can be stopped and restarted as many times as
4. The countup from zero option has a beep sound that sounds every minute For
there is a short beep and at second 00 there is a longer beep on the full minute
PROGRAMMED COUNTUP
1. TO use the programmed countup option, press MODE twice (from time) to get to the COUNTUP mode.
Provided the timer is stopped and at zero, the display will show 00:00 and TMR and JUST the up arrow.
2 press the MIN button to program in the required minutes, and the SEC button to program in the required
seconds, The display will now show your programmed tjme_ This will probably
be the optimum time for the Crosscountry course. This will stay visible untu
start/stop is pressed The lower digits will also sho•wthe same set time.
Press STARVSTOP button and the timer will count up in minutes and seconds
from zero. The display will show the word TMR and JUST the Up arrow.
During the countup period, there will be a beep sound for each full minute gone.
There will be a short at secorxis 57.5@59, and then a
5. The timer can be stopped and restarted as many times as required during
countdown. The lower d@ts will always show the set time.
6. During the final 30 seconds Ofthe programmed period there are extra warning beeps. A long beep
sounds at second 30. From 15,14.13.12 etc. there are short beeps building up to a long beep at fun time
(The end Ofthe optimum time).
7. At full tirne. the timer will continue to count up. The display will still show TMR and JUST the Up arrow.
NOTE The watch beeps in the final 30 seconds. If these beeps overlap with a minute beep, the
minute beep will NOT sound. The tinal 30 second warnings take preterence
57,58 & 59
ThRt
beg) at second 00.