Battery Replacement; Mains Power Supply - Lionelo Rio Bedienungsanleitung

4. Seat frame (lower part)
5. Backrest connecting element
6.
Backrest frame (upper part)
7.
Toy headband
8.
Cover
9.
Remote control
10. USB cable
REMOTE CONTROL (FIG. B)
1.
On / Off
2.
Increase the volume
3.
Next melody
4.
Lower the volume
5. Turn melodies on/off
6. Previous melody
7.
Rocking speed
INSTALLATION
1.
Slide the base elements onto the main module of the bouncer (fig. 1). You will hear a characteristic click.
Make sure the metal tab is visible.
2.
Place the bracket on the main module. Pay attention to the correct position of the bracket – its lower
part must easily fit into the main module (fig. 2). You will hear a characteristic click.
3.
Place the seat frame in the holes of the bracket (fig. 3). You will hear a characteristic click. Make sure
that the metal tabs are visible.
4.
Insert the backrest connecting elements into the backrest frame (fig. 4). You will hear a characteristic
click. Make sure that the metal tabs are visible.
5.
Place the backrest frame with the installed connecting elements into the seat frame (fig. 5). You will hear
a characteristic click. Make sure that the metal tabs are visible.
6. Place the cover on the frame (fig. 6). Make sure that the base of the headband is easily accessible (fig.
6a), otherwise it will not be possible to install the headband.
7.
Fasten the buckle located at the bottom of the cover (fig. 7).
8.
Insert the headband into the headband base (fig. 8). You will hear a characteristic click. Make sure that
the headband is firmly and securely installed.

BATTERY REPLACEMENT

1.
To replace the batteries, open the battery compartment (fig. 9) with a Phillips screwdriver (not included).
2.
Place 4 C/LR14 type batteries in the compartment. Pay attention to the correct polarity of the batteries
(+ and -). Place the batteries in an upright position.
3.
Close the compartment and tighten the screw.

MAINS POWER SUPPLY

To use the product connected to mains power supply, connect the USB cable to the main module of the
bouncer (fig. 10) and to the power adapter (not included), then to the electrical outlet.
When using the product, use only the power adapter with the appropriate specifications: 5,8V DC 1A.
USE
1.
Unbuckle the 3-point seat belts by pressing the buckles on both sides of the harness (fig. 11).
2.
Place the child in the bouncer. Place the middle part of the harness between the child's legs (fig. 12).
3.
Fasten the buckles of the 3-point seat belt. You will hear a click. Make sure the belts are not twisted.
EN ‑ 8 ‑