Operating The Plancha Grill - Verycook Plancha Gebrauchsanleitung

24

OPERATING THE PLANCHA GRILL

This appliance is designed exclusively for outdoor use. The purpose of the cooking plate is to
cook food.
NOTE: only use this appliance for the purpose for which it was designed. This appliance
must only be used by people who have read and understood this user manual and who
are therefore aware of the technical and safety rules.
Switching ON
Maximum heat
Minimum heat
•
The electronic piezo ignition is provided by an LR6 battery, supplied with the appliance.
•
To change the battery of the piezo ignition, you simply remove the buttons, then unscrew
the screws to remove the coating panel of your plancha grill and unscrew the red button
on the right-hand side of the front to be able to change the battery. Then reassemble all
of the parts.
A) SWITCHING ON THE PLANCHA GRILL
The gas supply is turned on by pressing and holding down the flame control knob whilst
turning it from the OFF position to the ON position (+) (see diagram above). At the same time,
press the piezo button located on the right-hand side at the bottom of the appliance. You
must maintain pressure on this button until ignition. Ignition of the burners must be observed
through the opening, located on the front of the plancha grill. The ignition button must be held
pressed in for 10-15 seconds until the burner is lit and the flame is maintained. In order to set
the appliance to a lower heat, slightly turn the knob in an anti-clockwise direction from (+) to
(-) (see diagram above).
OFF
Flame control knob
Piezo