Room thermostat II
Resetting to factory settings
You can reset the device to its factory settings as follows:
Open the battery compartment (8) and remove one of the batteries. Re-
place the battery while holding the rotary knob (4) pressed. Hold the knob
pressed until the status LED (3) on the room thermostat flashes orange
and "RES" appears on the display. Now release it briefly and press the
knob again and hold until the LED lights green. The device then restarts.
Please note that it can take a few seconds until the room thermostat is
ready for operation again.
݅ When resetting to factory settings, the settings and information are only
lost from the device and not from the Bosch Smart Home controller.
݅ To re-configure the device, first delete it in the device management
section of the Bosch Smart Home app and then add it again in the usual
pairing process.
Maintenance and cleaning
Removing or replacing batteries
To remove or replace the batteries, remove the device from the mounting
plate (9) or first remove the mounting bracket (10). Open the battery com-
partment(8). Remove the batteries. Take care to ensure the correct polarity
when replacing them.
The device does not require maintenance. Leave any repairs to a specialist.
Clean the device with a soft, clean, dry and lint-free cloth. When cleaning,
do not use any cleaning agents containing solvents.
Simplified declaration of conformity
Robert Bosch Smart Home GmbH hereby declare that the radio
equipment type Bosch Smart Home BTH-RM corresponds with the
directive 2014/53/EU. The complete text of the EU declaration of confor-
mity is available via the following web address:
→ https://eu-doc.bosch.com
Robert Bosch Smart Home GmbH hereby declares that the radio
system type BTH-RM complies with Regulation 2017. The full text of
the declaration of conformity is available at the following internet
address:
→ https://gb-doc.bosch.com
↑Contents
8-750-002-892 | V001 | 01/2024
English | 10
Bosch Smart Home