Parts And Components; Before Use; Installation - Cecotec Proclean 5010 Inverter Bedienungsanleitung

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1
A. Control panel
B. Turntable shaft
C. Viewing window
D. Door
E. Lock system
F. Microwave interior
G. Glass turntable
H. Turntable ring assembly
I. Turntable shaft
NOTE:
The graphics in this manual are schematic representations and may not exactly match the
device.

2. BEFORE USE

- This appliance is packaged in a way as to protect it during transport. Take the appliance
out of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the appliance
when transporting it in the future. In case the original packaging is disposed of, make sure
all packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
- Microwave
- Glass turntable
- Turntable ring assembly
- Turntable shaft
- Instruction manual
52 PROCLEAN 5010 INVERTER/PROCLEAN 5010 INVERTER WHITE

3. INSTALLATION

Turntable installation
1. Clean the inside of the microwave and put the turntable back in place.
2. If you are installing it for the first time, be sure to remove all packaging and shipping
tape from the turntable shaft. Before using the appliance for the first time, position the
turntable correctly.
3. Also clean the interior of the appliance and its accessories.
Installing the turntable
Fig. 2
1. Place the ring assembly in the corresponding hole.
3
2. Place the turntable on top of the ring
1
3. Fit the slots at the bottom of the turntable between the three shaft arms.
4. Make sure that the turntable fits on the shaft
31
inner hole of the appliance.
5. The rollers must fit into the rail at the bottom of the turntable.
NOTES:
- Never place the turntable upside down. The rotary motion of the turntable must never be
blocked.
- The turntable, shaft and ring assembly must always be installed before starting the
microwave.
- Food and containers must always be placed on the glass turntable.
- If the glass turntable or the turntable ring assembly cracks or breaks, please contact the
official Cecotec Technical Support Service.
Worktop installation
1. Remove all packing material and accessories.
2. Check the microwave to see if it is damaged.
NOTE: do not install the microwave if it is damaged.
3. Remove any protective film from the surface of the microwave.
NOTE: do not remove the mica plate protecting the magnetron inside the microwave cavity.
Installation instructions and specifications
Fig. 3
1. Place the microwave on a level surface. Make sure that there is nothing obstructing the air
inlet and outlet grilles.
2. The minimum installation height must be 85 cm.
3. The rear of the appliance must be placed against a wall. Leave a minimum clearance
of 30 cm above the microwave. A minimum clearance of 20 cm is required between the
microwave and adjacent walls.
PROCLEAN 5010 INVERTER/PROCLEAN 5010 INVERTER WHITE
ENGLISH
.
3
and that it is correctly positioned in the
2
53