Onkyo A-8200 Bedienungsanleitung Seite 9

@ Batteries
The remote contro! transmitter is powered by two batteries.
Before using this unit for the first time, insert the two batteries
(included) as shown
in the diagram. The remote control trans-
mitter has no on/off switch. Average battery life is one year.
This period may be shorter depending on the frequency of use
and environment (temperature and humidity) in which the re-
mote control transmitter is used. If the remote control transmitter
does not operate even though front panel controls function
normally, the batteries should be replaced. Use only batteries
listed in the following chart.
AA
1.5V R6
UM-3
Manga-
nese
®
Remote sensor
Remote control transmitter
RC-143S/142S
Precautions
. Remove the batteries if the remote control transmitter is not going
to be used for a long time.
. The batteries of the remote control transmitter must be replaced
periodically. Remember, however, that commands will be re-
ceived only when the main power switch of the A-8200 is on.
. This unit uses infrared rays. Therefore, commands may not be
received properly if the front panel of the A-8200 is exposed
to bright light. To prevent this from occurring, place the A-8200
so that it is not directly exposed to a bright light.
. If the A-8200 is placed inside an audio rack behind a glass door,
the door should not use colored glass or have any decorations
on it since this could shorten the range or prevent commands
from being received.
. Use of other infrared remote control devices in the same room
may cause interference.
. The transmitter operates up to a distance of about five meters
(16 feet). the transmitting window must always be pointed at
the reception window when a command is sent to the A-8200.
. If this remote control transmitter does not operate properly,
confirm that the batteries are not dead. If the problem persists,
contact your Onkyo service center.