Atlas Copco Control Thin Legic Sicherheitshinweise Seite 5

Assembly Control Thin Legic
Regional Requirements
WARNING
This product can expose you to chemicals including lead,
which is known to the State of California to cause cancer
and birth defects or other reproductive harm. For more
information go to
https://www.p65warnings.ca.gov/
Safety
DO NOT DISCARD - GIVE TO USER
WARNING Read all safety warnings, instructions, il-
lustrations and specifications provided with this
power tool.
Failure to follow all instructions listed below may result
in electric shock, fire, and/or serious injury.
Save all warnings and instructions for future refer-
ence.
WARNING All locally legislated safety rules regard-
ing installation, operation and maintenance shall be
respected at all times.
Statement of Use
• For professional use only.
• This product and its accessories must not be modified in
any way.
• Do not use this product if it has been damaged.
• If the product data or hazard warning signs on the product
cease to be legible or become detached, replace without
delay.
• The product must only be installed, operated and serviced
by qualified personnel in an industrial environment.
Statement of use
This product is intended to be used to monitor tools.
No other use permitted. For professional use only.
WARNING This is a class A product. In a domestic
environment this product may cause radio interfer-
ence in which case the user may be required to take
adequate measures.
Safety Signal Words
The safety signal words Danger, Warning, Caution, and
Notice have the following meanings:
DANGER DANGER indicates a hazardous situation which,
if not avoided, will result in death or serious in-
jury.
WARN- WARNING indicates a hazardous situation
ING which, if not avoided, could result in death or
serious injury.
© Atlas Copco Industrial Technique AB - 9846 1192 00
CAUTION CAUTION, used with the safety alert symbol,
indicates a hazardous situation which, if not
avoided, could result in minor or moderate in-
jury.
NOTICE NOTICE is used to address practices not related
to personal injury.
Product Specific Instructions
Service and Maintenance
Preventing ESD Problems
The components inside the product and controller are sensi-
tive to electrostatic discharge. To avoid future malfunction,
make sure that service and maintenance is carried out in an
ESD approved work environment. The figure below shows an
example of an appropriate service work station.
Additional safety warnings
WARNING This apparatus must be earthed. Applica-
ble only to Class I (earthed) equipment.
WARNING Explosion Hazard
Lithium battery inside. Danger of explosion if battery is
incorrectly replaced.
Replace only with same or equivalent type recom-
►
mended by battery manufacturer.
Electrical safety
• Earthed equipment must be plugged into a socket that
has been properly installed and earthed according to
appropriate regulations. Never remove the earth pin
or modify the plug in any way. Do not use any adapter
plugs. Check with a qualified electrician if you are in any
doubt as to whether the outlet is properly earthed. Should
the equipment suffer electronic malfunction or break-
down, the earth provides a low resistance path to carry
electricity away from the user. Applicable only to Class I
(earthed) equipment.
• Avoid physical contact with grounded surfaces such
as pipes, radiators, ovens and refrigerators. There is
an increased risk of electric shock if your body is
grounded.
• Do not expose the equipment to rain or wet condi-
tions. Water entering the equipment will increase the risk
of electric shock. This instruction does not apply to
equipment classified as watertight or splash proof.
• For minimum electrical interference, locate the equip-
ment as far as possible from sources of electrical noise,
e.g. arc welding equipment etc.
Safety Information
5