Cleaning And General Care; Troubleshooting; Technical Specifications; Warranty - Bushnell R Serie Bedienungsanleitung

CLEANING AND GENERAL CARE

The lenses of your Bushnell R3-1200 laser rangefinder are multi-coated and have Bushnell's EXO Barrier™ coating for the highest light
transmission. EXO Barrier, quite simply, is the best protective lens coating technology Bushnell has ever developed.
As with multi-coated optics, special care must be taken to clean the lenses. Follow these tips for proper lens cleaning:
› Blow away any dust or debris on the lens (or use a soft lens brush).
› To remove dirt or fingerprints, clean with the supplied microfiber cloth rubbing in a circular motion. Using a coarse cloth or
unnecessary rubbing may scratch the lens surface and eventually cause permanent damage. The included washable microfiber
cleaning cloth is ideal for routine optics cleaning. Breathe lightly on the lens to provide moisture, then gently rub the lens with the
microfiber cloth.
› For a more thorough cleaning, photographic lens tissue and photographic-type lens cleaning fluid or isopropyl alcohol may be
used. Always apply the fluid to the cleaning cloth – never directly on the lens.
› The rangefinder is manufactured and tested to withstand water exposure up to IPX4 standards. It is water resistant but should
not be submerged.

TROUBLESHOOTING

Never disassemble your laser rangefinder. Irreparable damage can result from unauthorized service attempts, voiding the warranty.
If the unit does not turn on, the display does not illuminate:
› Press Power/Fire button.
› Check and, if necessary, replace the battery. If the unit does not respond to button presses, replace the battery with a good
quality CR2 3-volt Lithium battery.
If the unit powers down (the display goes blank when attempting to power the laser):
› The battery is either weak or low quality. Replace the battery with a new 3-volt lithium battery (CR2).
If the target range cannot be obtained:
› Make sure the display is illuminated.
› Make sure that the Power/Fire button is being pressed.
› Ensure that nothing, such as your hand or finger, is blocking the lenses at the front of the rangefinder that emits and receive the
laser pulses.
› Ensure the unit is steady while pressing the Power/Fire button.
NOTE: The last range reading does not need to be cleared before ranging another target. Aim at the new target using the display reticle, press the power button,
and hold until the new range reading is displayed.

TECHNICAL SPECIFICATIONS

SKU
Configuration
Ranging Accuracy
Range
Dimensions
Weight
Power Source
Field Of View
ARC Modes
Waterproof Rating
R3-1200
6x25
Accurate to +/- 1 yard
5–1200 Yards / 5–1097.3 Meters
112mm Length x 40mm Width x 73mm Height
180g
3-volt lithium (CR-2)
365 ft. @ 1000 yards / 111.3 meters @ 1000 meters
Bow Mode
IPX4
Click to read Warranty Details

WARRANTY

Warranty does not cover theft, loss, deliberate damage, or
cosmetic damage not affecting product Performance.
Valid only in the United States. Valable uniquement aux États-Unis.
Click to return to the Table of Contents.
5