Calibration; Declaration Of Conformity - Wohler Rl 300 Bedienungsanleitung

Declaration of conformity

Filter replacement
Fig. 23: Protective cap with internal filter
11.2

Calibration

12 Declaration of conformity
This product:
Product name: Wöhler RL 300 refrigerant detector
complies with the essential protection requirements laid down in the Council Directives
on the approximation of the laws of the Member States relating to electromagnetic
compatibility (EMC 2014/30/EU).
The following standards were used to assess the product with regard to electromag-
netic compatibility:
EN IEC 61326-1: 2021
IEC 61326-1: 2020
BS IEC 61326-1: 2021
Bad Wünnenberg, 15.08.2024
Dr. Michael Poeplau, Managing Director/Managing Director
38
Press the filter down with a pair of tweezers
•
and pull it out of the sensor cap.
Position the new filter in the same place.
•
NOTE!
Make sure that the 4 notches of the filter are
pushed over the ridges of the cap.
It is recommended that the Wöhler RL m300 is sent
to Wöhler once a year for calibration.