Deactivating The Automatic Sensor Zeroing; Manual Sensor Zeroing - Wohler Rl 300 Bedienungsanleitung

7.3.1 Deactivating the auto-
matic sensor ze-
roing
Fig. 16: Display, automatic
sensor zeroing is deactivated
7.3.2

Manual Sensor zeroing

Fig. 17: Display during manual sensor
zeroing
Automatic sensor zeroing is preset on the Wöhler
RL 300.
To deactivate or reactivate automatic sensor
•
zeroing, press and hold the M button for ap-
prox. 3 seconds.
If automatic sensor zeroing is deactivated, an "M"
appears in the top right-hand corner of the display.
Press and hold the M button for about 3 sec-
•
onds until automatic sensor zeroing is deac-
tivated.
An "M" appears at the top right of the display.
To start manual sensor zeroing, briefly press the
power button.
During sensor zeroing, a "0" flashes 3 times at the
bottom right of the display.
Operation
EN
33