eta Fenite Bedienungsanleitung Seite 13

– Check whether the data on the type label corresponds with the voltage in your socket.
The power cord plug may only be connected to the electrical socket complying with the
applicable standards.
– The appliance is intended for use in households only and for similar use! It is not
designed for use in hair salons or for similar commercial use!
– Do not plug the power cord in the electrical socket and do not unplug it with wet
hands or by pulling the power cord!
– Take care when handling the appliance, try to prevent injury (e.g. burns).
– Switch off the appliance right after its use, unplug it from power supply and let it
cool down. Then put it on a safe dry place, out of reach of children.
– When the appliance is switched on for the first time, short and slight smoke can come out
that does not mean any defect and it is not a reason for claiming a defect of the appliance.
– Do not wind the supply cord around the device, this will extend its lifetime.
– The power cord must not be damaged with sharp or hot objects, open fire, it must not be
sunk into water or bent over sharp edges.
– Never use the appliance for any other purpose than for that described in these
instructions for use!
– The producer does not guarantee any loss caused by improper handling of the appliance and
its accessories (e. g. electrical accident, fire, burn, hair damage) and its guarantee for the
appliance does not apply in the case of non–compliance with the safety instructions above.
II. FEATURES OF THE DEVICE (FIG. 1)
A – hairbrush straightener
A1 – ON/OFF rotary switch + operation mode selector
A2 – brush head with heated bristles
A3 – power cord
A4 – turning joint of power cord
A5 – hanging loop
B – protective travel case
III. INSTRUCTIONS FOR USE
Remove all packing material, take out the appliance. Remove all possible adhesion foils,
stick-on labels or paper from the appliance.
ON/OFF rotary switch + mode selector (A1)
Use to switch the device on/off and to set the required function:
" " – off;
" " – heating (red LEDs are on);
" " – heating + airflow (low rate – red LEDs are off);
" " – heating + airflow (high rate – red LEDs are on).
INSTUCTIONS FOR USE:
1. Connect the electric hairbrush to the mains and switch it ON.
2. Set the required operation mode.
3. Comb your hair gently from the roots to the tips just as with a regular comb. The hair will
start to straighten gradually.
4. Turn the hairbrush OFF after use, unplug it from the mains and allow it to cool down.
Use the hairbrush straightener with washed and dry or slightly wet hair, never with wet hair.
Note
13 / 27
EN