Onkyo TX-8270 Bedienungsanleitung Seite 41

> Before Start > Part Names
Audio TV Out You can enjoy audio through the speakers of the TV while this
unit is on.
"On": When this function is to be used
"Off (default value)": When this function is not to be used
0 The setting is fixed to "Auto" if "HDMI CEC" is set to "On". If
you change this setting, set "HDMI CEC" to "Off"
0 Depending on your TV set or input signal of the component,
audio may not output through the speakers of the TV even if
this setting is set to "On". In such case, audio is output from
the speakers of the unit.
0 If you operate the volume dial on this unit when audio that is
being input through this unit for output from the TV speakers,
audio is output from this unit. If you do not want to output
audio from the unit, change the unit or TV settings, or reduce
the volume of the unit.
Audio Return Channel You can enjoy sound of the HDMI connected ARC compatible
TV through the speakers connected to the unit.
To use this function, set "HDMI CEC" to "On" in advance.
"Auto": To enjoy the TV sound through the speakers connected
to this unit
"Off": When not using the ARC function
Auto Lip Sync This setting automatically corrects any desynchronization
between the video and audio signals based on data from the
HDMI LipSync compatible TV.
"On (default value)": Automatic correction will be enabled.
"Off": Automatic correction will be disabled.
∫ 2. Network
0 When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the setting
automatically. Further, to assign fixed IP addresses to each component, you must set
"DHCP" to "Disable" and assign an address to this unit in "IP Address" as well as set
information related to your LAN, such as Subnet Mask and Gateway.
Wi-Fi Connect the unit to network via wireless LAN router.
"On": Wireless LAN connection
"Off (Wired) (default value)": To connect via wired LAN
> Install > Initial Setup > Playback
Advanced Setup
Wi-Fi Setup You can configure wireless LAN settings by pressing ENTER
when "Start" is displayed.
0 Refer to "2. Network Connection" (P17) in Initial Setup for Wi-
Fi settings.
Wi-Fi Status The information for the connected access point is displayed.
"SSID": The SSID of the connected access point
"Signal": The signal strength of the connected access point
"Status": The status of the connected access point
MAC Address This is the MAC address of the AV receiver.
This value is specific to the component and cannot be changed.
DHCP "Enable (default value)": Auto configuration by DHCP
"Disable": Manual configuration without DHCP
If "Disable" is selected, you must set "IP Address", "Subnet
Mask", "Gateway", and "DNS Server" manually.
IP Address Displays/Sets the IP address.
Subnet Mask Displays/Sets the subnet mask.
Gateway Displays/Sets the gateway.
DNS Server Displays/Sets the primary DNS server.
Proxy URL Displays/Sets the proxy server URL.
Proxy Port Displays/Sets the proxy server port number when you enter
"Proxy URL".
| Supplementary Information | Others
41
En