HQ Power ARAZU II Bedienungsanleitung Seite 4

Damage caused by disregard
and the dealer will not accept responsibility
A qualified technician
Do not switch the device on immediately
•
Protect the device against damage
temperature.
This device is designed for professional
•
should only be used indoors with an alternating
Lighting effects are not designed for permanent
•
their lives.
Mechanical wear and the LEDs are not covered by warranty.
•
Keep this manual for future
•
Use the original packaging
Description
4.
Refer to the illustrations
1 fuse
2 power input
3 DMX output
4 remote control
5. Mounting instructions
Choosing a Mounting
The VDPL300BA
For proper operation,
metal housing.
Do not:
• Operate the device in environments
relative humidity higher than 75%.
• Operate the device in a closed environment
provided.
Secure Mounting
Risk of injury.
limits, determining
• itself checked regularly.
qualifications
Have the device installed
norms.
The carrying construction
without deforming.
The installation must always be secured with a secondary
o
Never stand directly
o
qualified technician
Install the device in a location with few passers-by
Make sure there is no flammable
o
The installation has to be approved
DMX-512 connection
Refer to the illustrations
When applicable, connect an XLR cable to the female 3-pin XLR output of a controller
•
and the other side to the male 3-pin XLR input [E] of the VDPL300BA.
can be linked through
XLR input and output
A DMX terminator
•
distance or is in an electrically
corruption of the digital control signal by electrical
plug with a 120Q resistor
of the last device in the
27/09/2011
of certain guidelines
should install and service this device.
by leaving it switched
use on stage, in discos, theatres,
reference.
if the device is to be transported.
on pages 2 of this manual.
in ut
Location
has been designed for indoor environments
the unit must be operated
with an ambient
Overhead mounting
the installation
Do not attempt
as improper installation
by a qualified person, respecting
must be able to support
below the device when it is being mounted,
check the device once a year and once before you bring it into service.
material
by an expert before the device is taken into service.
on page 2 of this manual.
serial linking. The linking cable should be a dual core, screened cable with
connectors.
is recommended for installations
noisy environment
between pins 2 and 3, which is then plugged into the XLR output socket
chain.
VDPL300BA
in this manual is not covered by the warranty
for any ensuing defects or problems.
after it has been exposed to changes in temperature.
off until it has reached room
current of 230 VAC/50 Hz.
operation: regular operation
5 DMX in ut
sensitivity
6
display
7
menu control
8
with an unobstructed
temperature
smaller than 10 m3 unless forced air convection
requires extensive experience:
material to be used... Have the material
to install the device yourself
may result in injuries.
EN 60598-2-17
10 times the weight of the device for 1 hour
attachment
that is inaccessible
within a 0.5 m radius
where the DMX cable has to run a long
(e.g. discos). The terminator
noise. The DMX terminator
etc. The VDPL300BA
breaks will prolong
adjustment
ush buttons
at temperatures up to 450C.
air convection
higher than 450C and a
calculating workload
and the device
if you lack these
and all other applicable
e.g. a safety cable.
removed or serviced.
to unauthorised
of the device.
Multiple VDPL300BA's
prevents
is simply an XLR
Rev. 01
to its
is
Have a
persons.
(not incl.)
CVeIIeman nv