Rimage Producer 7100 Benutzerhandbuch Seite 17

Aligning the PrismPlus printer
To align your PrismPlus printer, use the following instructions.
Required tools:
•
T25 Torx screwdriver
•
5/32" Allen wrench
1. Power on the autoloader.
2. Wait for the unit to complete initialization.
3. Prepare the unit for alignment.
a. Manually move the lift arm to the top
of the column.
b. To place a disc in the lift arm, press
the disc up into the lift arm while
pressing the disc release button.
c. To open the printer tray, press the
printer button.
4. Align the printer.
a. Slowly move the lift arm down until the disc touches the print pad.
Printer
Button
Side to Side
Alignment
Print
Pad
110867_A
Maintain the Producer III autoloader
Gripper
Holding Pins
Lift
Arm
Disc Release Button
Lift
Arm
11