Philips ADD6901 Bedienungsanleitung Seite 11

Sterilization
• The UV-C LED sterilizer in the �ltered water tank will start working for 1 hour
immediately after the dispenser is plugged in.
• Automatic sterilization: 1 hour after connecting power, the UV-C LED
sterilizer in the �ltered water tank will turn on for 10 minutes every 50
minutes.
• During the process of dispensing water, the throw-through type UV-C LED
sterilizer at the outlet waterway will remain active until the water
extraction is complete (Note: This feature is exclusive to speci�c models).
• " " will light up during UV-C LED sterilization , and it will turn off when
sterilization is not in progress.
Changing water
When the indicator of "
be changed, which will happen in the following conditions:
• Water in the tap water tank is at or less than the lowest water level;
• The TDS value of the tap water is too high;
• The water in the tap water tank has not been changed for 48 hours;
• To change the water in the tap water tank, remove the lid, lift the tap
water tank upward, and discard the drain water. Fill the tank with fresh
tap water, place it back to the appliance, and close the lid properly.
Note: Do not add water into the tap water tank without discarding the
drain water.
Winter mode
• When the inlet water temperature in the tap water tank in lower than 10 °C ,
winter mode can be set to heat the water to 25 °C .
• Long press the ambient button for 3 seconds, and press the water
extraction button. This is valid for single extration only.
" �ashes, the water in the tap water tank needs to
11
3s
1
2