Werbung
Verfügbare Sprachen
Verfügbare Sprachen
13/
ADDITIONAL INFORMATION
13.1 TROUBLESHOOTING MALFUNCTION
The cartridge cannot be screwed in.
1: follow steps 2-3 of the start-up procedure.
2: If the problem persists, send your
ABS®SYSTEM to ABS for service.
The airbags are difficult to remove from the
compartments
and
are
hard
1.
Were
the
airbags
folded
2. Did the weight of the cartridge match the filled
weight?
3. If you answered both with yes you must send
the
airbag
in
for
4. If you are unsure about either one of these
points, perform a practice activation.
5. If the problem persists send the ABS®-
System in for service.
After inflating the airbags there is a definite
background noise
1. This noise is due to the release valve
equalizing the pressure.
2. After a few minutes the pressure drop should
not
be
clearly
visible
3. If the pressure drop is still clearly visible,
the system needs to be repaired. Send the ABS-
System in for service.
48
13.2 WARRANTY
•
To extend your warranty of the ABS®-
System from 2 years to 4 years please
complete the warranty card online no later
than 30 days after your purchase under:
to
inflate:
properly?
https://abs-
airbag.com/products/garantieverlaengerung
service.
any
more.
13.3 TECHNICAL DATA
•
Volume of airbag: 2 x 75 litre airbags
•
Weight of system: 1200g
•
Airbagmaterial: Polyamid 6.6
•
Release: Mechanical by Bowden-System
•
Within approx. 1 second, 90 litres (23,8 US
gallon) of a gas-air mix is forced into the
two airbags while the remaining approx. 60
litres (21,1 US gallon) will take 1.5 seconds
(depending on outside temperature and
elevation).
•
Cartridges:
Are made from highly durable materials
with an allowable pressure of more than
300 bar (4400 psi). Depending on the
model, the cartridges comply with the
guidelines of the EG or DOC / TC for North
America.
•
Carrying system:
Complies with the TÜV requirements for
extreme operational demands. The
carrying system withstands a load of
3000N (674lbf).
•
Operating temperature: von -40°C bis
+50°C
Subject to technical modifications.
13.4 PERMITS AND CONFORMANCE
•
The lower limit of 20 activations as
prescribed
by
the
EN
standard
guaranteed.
The
service
life
and
functioning of the equipment depends on
the level
of
use.
If
the described
maintenance intervals are observed, we
recommend replacement after a service
life of 10 years.
Manufacturer:
ABS Sports + Protection GmbH & Co. KG
Aachener Weg 66
88316 Isny im Allgäu
Country of origin:
Germany
Typ:
ABS®-Avalanche Airbag System
is
49
Werbung
