Operation - SEVERIN SM 9495 Gebrauchsanweisung

Before using for the fi rst time
Remove any packaging materials and check
that all components are present.
Before the appliance is used for the fi rst
time, or after extended periods of non-use, it
should be thoroughly cleaned as described
in the section Cleaning and care.
Storing accessories
The stirring and heating accessories may be
stored in the lid. First, put the smooth collar
in with its opening facing up, and then fi t the
serrated head inside.

Operation

We recommend using milk with a high
protein content. For best results, the
milk should be taken from the refrigerator
immediately before frothing.
The underside of the container and the contact
area on the inside of the base must be clean
and dry.
Choosing the stirring head
∙ For frothing and heating milk at the same
time, use the serrated head.
∙ For simply heating milk, put the serrated
stirring head in the collar, making sure
they are fi tted inside the container with the
collar facing down.
Fill amounts
∙ Always observe the minimum mark and
ensure the container is fi lled with at least
60 ml milk.
∙ For frothing, fi ll the container to a
maximum of 120 ml (lower max mark
∙ For heating, fi ll the container to a
maximum of 180 ml (upper max mark
).
10
Heating or frothing milk
∙ Place the container onto the base.
∙ Remove the lid from the milk container.
∙ Place the appropriate head onto the
mounting protrusion inside the bottom of
the container.
∙ Put the required amount of milk into the
container.
∙ Place the lid on the container.
∙ Insert the plug into a suitable wall socket.
Press the On/Off switch.
∙ There is then a beep-signal, and the
motor can be heard starting up.
∙ The appliance begins to heat up and stir
the milk.
∙ Once the milk is suffi ciently hot, the
stirring and heating processes stop
automatically, and a number of beep-
signals are heard.
∙ You can now remove the milk container
from the base.
∙ Pour out the hot milk, or use a suitable
spoon to take off the milk froth.
∙ The cooling system continues to run for a
brief period. Remove the power cord from
the socket only when it has stopped. .
Remarks
Always allow the appliance to cool down
fi rst, before starting a new cycle.
Making hot cocoa
The appliance is also suitable for the
preparation of cocoa beverages. Proceed
as described in 'Heating up or frothing milk'
(having fi tted the stirring insert and collar)
and turn the appliance on. Take off the lid
). after about a minute, put in the desired
amount of cocoa powder and replace the lid.
To prevent the mechanism from becoming
blocked, do not use grated chocolate or