CANGAROO Easy Check Bedienungsanleitung Seite 17

drying after disinfection process.
4.Note:
Ensure that no liquid enters the interior of the thermometer.
Never use abrasive cleaning agents, thinners, or benzene for cleaning, and never immerse the thermometer in water or
other cleaning liquids.
Take care not to scratch the surface of the probe lens and the display.
If the visual inspection identifies unacceptable deterioration such as corrosion, discoloration, pitting, cracked, the device
should not be further used and should be discarded.
If the thermometer has been used in patients, visually inspect the thermometer to determine if there is stain or oil on the
casing or probe after each use, and follow the instruction of cleaning and disinfection to cleaning your thermometer.
If you have problems, while using the thermometer, take a look at the guidelines in this manual for solving the problem. If the
problem still exists, contact with the trade agent, which you bought the product from.
1. Display shows temperature, higher than 42,9 °C (109,2 °F)
The temperature is in Fahrenheit. Change the measurement to Celsius.
2. Display shows temperature lower than 32 °C (89,6 °F)
For measuring the surface temperature, press button "BODY" and set for measurement on „BODY". If the device is in mode
„Surface temperature" , the temperature 32 °C (89,6 °F), which display will show, taking into account the external body
temperature, instead internal.
3. Display show the message "Hi"
When using contactless thermometer, model Easy Check, the message "Hi" can show on the
display. In this case the temperature is either over the chosen range or over 42,9 °C (109,2
°F) in„BODY" mode.
4. Display shows message "Lо"
When using the contactless thermometer, model Easy Check, the message "Lo" can show on
the display. In this case, recorded temperature is either under chosen rage or under 32 °C
(89,6 °F) in „BODY" mode.
The display shows this message because of many reasons. Check the below list with the main possible problems:
Reasons the display shows the message "Lo"
Temperature measurement is difficult from hair or sweating.
Temperature measurement is difficult from air flows or sharp
changes in environment temperature.
Successive measurements of the temperature are too close
one after another and the thermometer do not have time to
Measurement area is away from the thermometer.
Symbol
IP22
XI.TROUBLESHOOTING
restart.
XII. SYMBOL EXPLANATION
Degree of protection against harmful ingress of water and particulate matter
2 Protected and against solid foreign objects of 12.5mm Φ and greater
2 Protection against vertically falling water drops when ENCLOSURE titled up to 15°
Ensure that there are no obstacles or moisture before
Ensure that there are no air flows around the area, in which
the temperature is measured, this can affect the infrared
Leave interval 3-5 secs. Between measurements;
recommended is pause for 15 sec.
Measure the temperature on recommended distance
(around 3-5 cm, 1.2 ~2.0 inches).
Explanation
Trade mark
IEC 60417-5333, type attached part BF
IEC 60417-5031, Direct current
Advise
temperature measurement.
reading.
16