Operation; Fill Water Tank; Application - Genius Invictus Gebrauchsanleitung

Operation

Fill water tank

NOTE!
DO NOT ADD ANY DESCALING AGENT, AROMAS, CLEANING ADDITIVES, OILS
OR OTHER CHEMICALS INTO THE WATER TANK.
WE RECOMMEND USING DISTILLED WATER TO AVOID DEPOSITS.
SWITCH OFF THE APPLIANCE AND DISCONNECT THE MAINS PLUG FROM
THE SOCKET WHEN FILLING THE WATER TANK.
THE FILLER OPENING MUST NOT BE OPENED DURING USE.
1. Turn the cover of the water tank anti-clockwise to open it (see fig. D).
2. Fill the water tank with the measuring cup and close the water tank again with the cover (see fig. E).
3. Fill the water tank with distilled water to prevent calcifying.

Application

NOTE!
ONLY USE THE DEVICE WITH A FILLED WATER TANK.
ONLY USE THE DEVICE ON SUITABLE SURFACES.
1. If necessary, unwind the power cable and insert the plug into a functional socket.
2. The three blue LEDs on the main unit flash alternately while the appliance is heating up.
3. As soon as the first LED lights up solid blue (after approx. 25 seconds), the appliance is ready for operation.
4. The appliance starts automatically with min. steam strength. You can increase the steam strength by pressing the
mode button (see fig. F).
1 x press - second LED lights up blue - medium vapour strength
2 x press - third LED lights up blue - max. vapour strength
5. Press the mode button again to switch back to min. vapour strength.
Use as a floor steam cleaner
1. Place the cleaning foot on the floor, step on the side of the cleaning foot with your foot and pull the handle
towards you to activate the steam function (see fig. G).
2. Move the cleaning foot over the surface to be cleaned. The cleaning foot should remain in motion while cleaning.
Do not clean the same area for long periods of time.
3. If you place the running appliance in an upright position and the lock on the cleaning foot engages, the steam
function is deactivated and the appliance switches to standby mode. In standby mode, the appliance restarts as
soon as it is placed in an inclined position.
4. For carpet cleaning, place the cleaning foot with the microfibre mop pad in the carpet glider. This makes it easier to
move the cleaning foot over the carpet.
Instruction manual
GB
19