Operation Procedure - Autool Pt660 Bedienungsanleitung

Operation
procedure
● Connect the pressure input cables to the corresponding slot,
insert them into the top of the instrument for L/R, and tighten
the nut.
Long-press the power switch key [
●
the tester and enter the main menu.
● Long-press the zero key [
spheric pressure calibration.
● Connect the adapter for the specific vehicle model to the
measurement probe.
Press the unit switch button [
●
are available).
● Press the wheel switch button [
wheels (left front/right front) or rear wheels (left rear/right rear)
for measurement. After measuring the front wheels, switching
to the rear wheels will default to locking the previous set of
data.
Press the measurement button [
●
ment.
After measurement completion.
●
● Long-press the unit switch button [
toggle between viewing maximum/minimum pressure.
NOTE
The device will emit an alarm when the pressure reaches 220
Bar.
The device will automatically power off after 5 minutes of inactiv-
ity or no pressure.
] for 2 seconds to perform atmo-
] to select the unit (three units
] to start pressure measure-
9
] for 2 seconds to turn on
] to choose either front
] , for 2 seconds to