ROBBE 21110 Bedienungsanleitung Seite 16

ENGLISH
Install the receiver and power supply in the fuselage and connect all electrical connections.
Insert the wing joiner into the provided led-through in the fuselage.
Now take a wing half and put it on the wing joiner until the torsion pins are threaded into the root and
fasten the wing with the M4 hexagon socket screw and washer on the fuselage. Repeat this step with
the other wing half.
The center of gravity is located 115mm behind the leading edge. For faster aerobatics, the center
of gravity can be moved further to the rear.
Depending on the equipment, it may be necessary to bring about 100g trim weight in the fuse-
lage nose. Fix the battery and weight well, but leave enough room to move the center of gravity.
Now switch on your transmitter with the preset model memory and receiver and, as far as pos-
sible, adjust all the rods mechanically.
Then check the servo directions and travels as shown in the table below.
The settings of different phases of flight oblige your own taste.
16
INSTALLING AND TUNING PROCESS
15
16
17
18
19
20
21
22