Werbung
5. Detector Cleaning
Dust on the detector may cause blemishes in the image. To avoid
detector damage, we recommended you to contact the nearest
dealers or our service centers for help.
If you have to clean the detector on your own, please follow the
instruction.
Steps:
1. Remove the interchangeable lens carefully, as shown in page 5 –
D.
2. Use pressurized air from a compressed air canister (not
included) to blow the dust off.
3. If there still have blemishes, use a supplied cleanroom wiper
dipped in anhydrous ethanol to wipe it.
Note:
Wear a pair of rubber gloves or rubber finger cover (not included)
at first, in case of the chemical corrosion or the remaining
fingerprints.
Please wipe the detector gently in a fixed direction.
6. Tilt Lens and Screen (Page 6 – E)
You can tilt the lens and screen, as shown in page 6 – E.
7. Mount Hand Strap (Page 6 – F)
Steps:
1. Thread the hand strap through the hand strap clutch.
2. Thread one end of the hand strap through the two hand strap
attachment points.
3. Thread hand strap through the hand strap buckle (as shown in
the picture), and fasten the hand strap.
4. Adjust the tightness of the hand strap as needed.
8. Mount Neck Strap (Page 6 – G)
Mount the neck strap on the neck stap attachment points (No. 16 &
Component & Interface (Page 1 to 2 –
34 in
camera to prevent accidental falls. Thread one end of the neck
strap through one neck attachment point, and the fasten collar and
A)) at both sides of the
12
Werbung
