Getting Started; Charging Battery; Setup Before Starting - Hpi Racing Maverick Atom Schnellstartanleitung

2

Getting Started

2 - 1

Charging Battery

Only use the included charger to charge the battery pack.
Do not leave the battery back unattended whilst charging.
Do not use damaged or leaking batteries and chargers.
Children should not charge the battery without adult supervision.
Always disconnect the battery from the ESC and remove it from the vehicle when you are not using it.
Please fully charge the battery before each use.
Caution
Do not leave the battery uncharged for a long time.
Do not fully discharge the battery while driving the vehicle.
Do not charge the battery in wet or humid conditions. Charge only in dry conditions.
The USB Charger requires a USB Adaptor with an output of at least 2A (Not included)
1) Connect the charging socket to the supplied battery packs power plug. The connectors are sided and have a clip to secure it
in place. Do not force together and always check you have the connection the right way round.
2) The charger will automatically start to charge your battery pack. The USB charger will stop charging when it detects the
battery pack is at full charge.
*Error: Voltage out of charging range. If this is reoccurring your battery pack may be damaged and need replacing.
2 - 2

Setup Before Starting

1
Transmitter Battery Installation
Open the battery holding tray to expose the empty battery slots. Insert 3 AA batteries into the marked spaces.
Please note the correct direction of the batteries. Incorrect battery insertion could damage the transmitter.
2
Battery installation
You need to insert the battery pack in the open section for
the battery. Use the straps provided to secure the battery in
place.
Once fastened and secured please connect the battery plug
into the speed controller plug noting correct polarity. Red to
red, black to black.
LED Status:
Red:
Flashing Green:
Green:
Flashing Red:
9
Standby
Charging
Charge finished
Error*
en