Worx WX710 Originalbetriebsanleitung Seite 10

such as the times when the tool is switched off and when
it is running idle but not actually doing the job. This may
significantly reduce the exposure level over the total
working period.
Help to minimize your vibration exposure risk.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Avoid using tools in temperatures of 10
Plan your work schedule to spread any high vibration tool
use across a number of days.
ACCESSORIES
Spanner
Metal grinding disc
Auxiliary handle
Anti-vibration
auxiliary handle
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to the
accessory packaging for further details. Store personnel
can assist you and offer advice.
10
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE:
The machine is intended for cutting, roughing and
brushing metal and stone materials without using water.
For cutting metal, a special protection guard for cutting
(accessory) must be used.
ASSEMBLY AND OPERATION
Action
ASSEMBLY
Assembling Auxiliary Handle
Assembling Grinding/Cutting Disc
Angle Grinder
C or less
0
WX711
WX710 WX712
WX711.1
1
1
1 1
/ /
Figure
See Fig. A
See Fig. B1,B2,B3
Adjusting wheel guard
NOTE: Before any work on the
machine itself, pull the mains
plug. For work with grinding or
cutting discs, the protection
guard must be mounted.
The coded projection on the wheel
guard (10) ensures that only a guard
that fits the machine type can be
mounted.
Open the clamping lever (9). Place
the wheel guard (10) with coded
projection into the coded groove
on the spindle of the machine head
and rotate to the required position
(working position).
To fasten the wheel guard (10), close
the clamping lever (9).
The closed side of the wheel
guard (10) must always point to
the operator.
/
OPERATION
1
Plugging in the Power
Using On/Off Switch
Hand Grip Areas
Rough Grinding
WARNING! Never use a
cutting disc for roughing.
Cutting
WORKING HINTS FOR YOUR
ANGLE GRINDER
1. Always start at no load to achieve maximum speed
then start working.
2. Do not force the disc to work faster, reducing the Disc's
moving speed means longer working time.
3. Always work with a 15-30 angle between disc and
workpiece. Larger angles will cut ridges into the
workpiece and affect the surface finish. Move the
angle grinder across and back and forth over the
workpiece.
4. When using a cutting disc never change the cutting
angle otherwise you will stall the disc and angle
grinder motor or break the disc. When cutting, only cut
in the opposite direction to the disc rotation. If you cut
in the same direction as the disc rotation the disc may
push itself out of the cut slot.
5. When cutting very hard material best results can be
achieved with a diamond disc.
6. When using a diamond disc it will become very hot. If
this happens you will see a full ring of sparks around
the rotating disc. Stop cutting and allow to cool at no
load speed for 2-3 minutes.
See Fig. C
See Fig. D
See Fig. E
See Fig. F
See Fig. G
EN