Werbung
Issues charging the chair.
1. If the chair wont charge a er hours of trying.
2. The chair won't start charging, and the light indica ng
charging on the hand control is not blinking.
HMN a/s
27
4. If none of the lights on the hand control is on (a er pressing
any of the bu ons), and the chair can't elevate or lt.
Check that all the wires are correctly plugged in.
Try charging the chair for 24 hours a er checking the wires.
If the problem con nues a er this it might be a defect ba ery
or other electrical components.
Contact HMN for further advise and trouble shoo ng.
The picture on the le shows the control box:
Check that the outlet you are using has power in it, and
that it is turned on.
At the top and to the right on the hand control is a light
indica ng charging status. This light will blink if the ba ery
is charging.
At first when you plug the wire for charging in to an outlet
this light will not blink, it will just light up.
A er some me the light will start to blink, and this indi-
cates that the chair is charging. The reason some me
might pass before it starts charging is that the system is
prepping the ba ery to receive power. This might take
extra me if the ba ery is cold, or the chair is very low on
power.
Try to reset the system as described above in the first pas-
sage. If the problem con nues contact HMN for further
advice.
3. The charging light on the
hand control is not ligh ng
up or blinking even if the
chair is plugged in to an
outlet.
Check that the charging wire
connected to the control box
is correctly plugged in. Check
that the red locking ring is
mounted inside the plug on
the control box. This issue is
normally because the charg-
ing wire or the locking ring is
incorrectly mounted. It can
also be a faulty ba ery.
If the red locking ring is
mounted correctly it can be
seen through the plug like on
the picture to the le :
Werbung
