Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Insertthe anchor plug into the screw hole and hammer it in until the head of the anchor plug is flush with the wal .
4 use the two provided screwsor 3.5 x 25 mm countersunk screwsto screw into the two anchor plugs. Besure to leave a 5 mm
(1/5-inch) gap between the head of the anchor plugs and the screws,which will allow for easydevice mounting.
5. Mount and lock the device onto the wall by aligning the two mounting slots on the back of the device with the screwson the
6. Test the device by pushing the test button to make sure that the device is functioning properly.
• 14.
Installation
on a Table
The base of the detector hastwo feet built into the design that al ow it to stand free y on a flat surface.
When placing on a shelf, p easeadhere to the recommended placement asdescribed in Where to Instal
NOTE:
.15.
Werbung
