Herunterladen Diese Seite drucken

x-sense XC01 Bedienungsanleitung Seite 10

Vorschau ausblenden Andere Handbücher für XC01:

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Alarm
Testing
Besure to test your CO alarmswhen you turn them on for the first time. In addition to the weekly test you should perform, It IS
also recommended to test the alarm after returning from a ong trip or vacation.
Type
XCOI
IXC04
Push the test button once to wake up the alarm,
Action
and pressthe test button again when the LCDis on.
The device beeps 4 times twice, and the LEDwil flash red.The LCDwil display"
Device
COconcentration recorded sincethe previous reset,and final y "O."This indicatesthat the device is
Response
functioning properly.
•The test function accurately tests the alarm's CO sensing circuit without the need of testing CO
NOTE.
Peak CO Concentration
Memory and Reset
The peak CO concentration feature is helpful in identifying if there have been any dangerous CO readings sincea peak CO
concentration
reset.
XC01-R/XC04-R
Push the test button.
," "PAS," the peak
.16.
Eachtime you push the test button, the LCDdisp aysthe peak COconcentration recorded since the previous reset.The peak CO
concentration will be displayed for 5 seconds and then the device will enter standby mode. In the examp e, 300 ppm was the
maximum
CO concentration
recorded since the unit was last reset.
Peak CO Concentration
Reset: During the 5 seconds when the LCDdisp ays the peakCO concentration, pressand hold the
test button for 3 seconds,the device wil beep, the LEDwil flash green, and the peak CO concentration will be resetwith LCD
disp aying
NOTE: If the carbon monoxide concentration is lower than 30 ppm, it will not be recorded in the peak COconcentration.
Silence
Mode
Pressthe test button during an a arm to have the unit enter silence mode. If the CO density still exceedsthe alarm threshold after
6 minutes, the unit will re-enter the alarm state. Otherwise, the unit will exit the silence mode after 9 minutes and resume normal
operation. Ifthe CO concentration is above 300 ppm, the silencefunction cannot be enabled.
LCD Display
.17.

Werbung

loading

Diese Anleitung auch für:

Xc04Xc01-rXc04-r