Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before use,pul out the battery insulating fi m from the battery compartment to power on the device, After the device is turned
on, the buzzerwil beep once, the LCDbacklight wi light up, and the LEDindicator will flash through 8 cyces
(yelow/green/red). The device will then enter standby mode.
Follow the process below to open the battery compartment cover:
Hold the alarm with both hands and put your thumbs on both ends of the battery compartment cover. Then,push the cover
upwards with some force to remove it.
9
9
.12.
A WARNING
CONSTANT
EXPOSURE
TO HIGH OR LOW TEMPERATURES
Wall Mounting
1 Choose a suitable installation ocation by referring to the "Whereto Install"section,
2. Remove the indication stickerfrom the packaging and referto the hole ocations on the sticker.Draw two screw holes
according to the sizeand ayout of the mounting ho es on the back of the product. Drill the screw holes 30 mm (1.18inches)
deep using a Ø
mm (1/4-inch) dril bit. Note that the distance between the center of the two holes is 74 mm (2,9inches).
Drill hole spacing
2.9 in,'74
mm
AND HIGH
HUMIDITY
MAY REDUCE
BATTERY
LIFE.
Mounting Slots
.13.
Werbung
