RONDELL RDE-1117 Betriebsanweisung Seite 22

5. No brewing unit. When the «
brewing unit is not installed or installed incorrectly.
6. Used coffee grounds container
When the « » icon lights up
1) it indicates that the used coffee grounds container is not in-
stalled or installed incorrectly.
2) it indicates that the used coffee grounds container is full and
needs to be emptied.
(By default, the system prompts to empty the used coffee
grounds container once every 8 cups of coffee.)
7. Descaling needed. When the «
the coffee machine's water delivery system needs descaling.
8. Water system warning. When a rectangular «
symbol appears on the control panel's display, it indicates that
water is not passing through the coffee machine's internal water
delivery system. Make sure that there is water in the water tank
and the water tank is installed correctly, press the button «MENU/
EXIT» « » to start the water supply pump again, to eliminate
the air plug in the water supply system.
MACHINE MENU AND SETTINGS
In the standby mode, press and hold the button «MENU/EXIT»
« » for 3 seconds (fig. 14) to enter the settings menu.
Note: if no buttons on the control panel (7) are pressed within
15 seconds, you will hear two short sound signals and the cof-
fee machine will return to the standby mode.
By sequentially pressing the button «MENU/EXIT» «
you can enter the interface for adjusting parameters of bev-
erage preparation, coffee temperature, automatic switch-off
time of the coffee machine, return the beverage preparation
parameters to factory settings, activate the decalcination
mode.
1. Setting of parameters of «Espresso» and «Americano»
preparation
A. After entering the settings menu, the buttons «Espresso»
« » and «Americano» « » will start simultaneously flash-
ing on the control panel (7), by pressing any button, you can
change the parameters of preparation of the drink according
to your preferences.
B. For example, in the settings menu, press the button «Espres-
so» « » to enter the interface for adjusting the amount of
ground Espresso coffee, while the amount of ground cof-
fee set by default will be shown on the display of the control
panel (7). Press the button «+» or «-» to increase or decrease
the amount of ground coffee, to confirm, press the button
«MENU/EXIT» « » and go to the interface for adjusting
the volume of brewed coffee. Press the button «+» or «-» to
increase or decrease the volume of brewed coffee, to confirm
and return to the settings menu, press the button «MENU/
» icon lights up, it means the
C. For example, in the settings menu, press the button «Amer-
» icon lights up, it means
»
D. After completing the Espresso or Americano setup, press the
2. Setting of the temperature
After returning to the settings menu, press the button «MENU/
EXIT» «
(fig. 15).
Press the button «+» or «-» to increase or decrease the coffee
»,
temperature. Available temperature adjustment range is 75-95 °С
with the step 5 °С. To confirm, click the button «MENU/EXIT»
«
3. Setting the automatic switch-off time
After returning to the settings menu, press the button «MENU/
EXIT» «
terface (fig. 16).
Press the button «+» or «-» to select the automatic switch-off
time, it can be set to 0.5 hours, 1 hour, 2 hours... 24 hours. To
confirm, click the button «MENU/EXIT» «
the next step.
4. Return to the factory settings
After returning to the settings menu, press the button «MENU/
EXIT» «
face (fig. 17).
To confirm, press the button «STEAM/OK» «
down will start to appear on the display of the control panel (7).
Once the countdown is finished, you will hear two short sound
signals and the coffee machine will switch to the standby mode.
5. Descaling
To descale the coffee machine, use specialized cleaning agents
in liquid or tablet form. It is recommended to prepare about 1,5 li-
ters of cleaning solution.
22
EXIT» « », to return to the previous interface, press the
button «STEAM/OK» « ».
icano» « » to enter the interface for adjusting the amount
of ground Americano coffee, while the amount of ground cof-
fee set by default will be shown on the display of the control
panel (7) (fig. 16). Press the button «+» or «-» to increase or
decrease the amount of ground coffee, to confirm, press the
button «MENU/EXIT» « » and go to the interface for ad-
justing the volume of brewed coffee. Press the button «+» or
«-» to increase or decrease the volume of brewed coffee, to
confirm, press the button «MENU/EXIT» «
the interface for adjusting the volume of hot water. Press the
button «+» or «-» to increase or decrease the volume of hot
water, to confirm and return to the settings menu, press the
button «MENU/EXIT» « », to return to the previous inter-
face, press the button «STEAM/OK» «
button «MENU/EXIT» « » to proceed to the next step, or
continuously press the button 6 times to return to the standby
mode.
», and go to the temperature control interface
» and proceed to the next step.
» 2 times, and go to the switch-off time setting in-
» 3 times, and go to the factory settings reset inter-
» and go to
».
» and proceed to
», and the count-