BSS Flow 8 Bedienungsanleitung Seite 25

BSS-Streaming Service
Troubleshooting
Occurred error
The built-in components Check that the mains plug is
do not work. plugged in correctly.
whether mains voltage is
With battery operation Check whether battery
- the built-in components voltage is present (is the LED
do not work on the front illuminated?).
Check whether the battery
has sufficient voltage/
capacity to operate the Flow
Check whether the polarity
of the battery corresponds to
the connection diagram of
whether the built-in fuse
Connected devices are not Remove all charging plugs
charged via the internal from the devices in the
USB-C or Lightning cable. holder or, if necessary, from
an external USB charging
port. Switch the case off and
on again at the central
No or only a low audio Make sure that the two XLR
signal at the optional RCA plugs are plugged into the
(cinch) outputs MAIN-Out sockets of the
appropriate signal level is
Page 48
BSS-Flow 8 Case
First action Further action
Switch the on/off switch on
the Flow 8 case back on.
Check Plug into a different socket/
circuit.
present.
Remove all connected
loads (e.g. on the USB port)
and switch the on/off
switch back on.
Charge the battery if
necessary
8 Case.
If necessary, have the
appropriate connection
cables assembled by a
the Flow 8 case. specialist.
Check Remove all connected
voltage sources. Use a
has tripped. screwdriver (against the
UZS) to open the fuse
holder attached to the
front. Remove the fuse and
replace it with a spare fuse
of the same rating (5A/
flash)
Only connect one device at
a time to the available
charging connections.
switch.
Check whether the inputs
of the external connected
device are suitable for
Flow 8 and that an unbalanced input signals. If
possible, switch to Line In
present there. level (-10dB).
Operating instruction EN
Maintenance and service
Check that all cables and connection lines are undamaged each time you use the appli-
ance. Regularly check the mains connection cable in particular for any damage.
Keep the case clean. The surfaces can be cleaned with a damp cloth.
Note: Plastic cleaners and especially disinfectants can attack the surface of the Flow 8 case.
Therefore, first test cleaners and disinfectants specially approved for plastic on an inconspicu-
ous area to check for changes to the material.
Information on cleaning the installed components can be found in their operating and
commissioning instructions or on the manufacturer's website.
Service address
In the event of service or spare parts requests, please contact the address below. In any
case, have the 10-digit serial number of the BSS case ready. You can find this on the type
label on the underside of the case.
BSS Streaming Service
Mühlstraße 80
D-73655 Plüderhausen
Germany
info@bss-streamingservice.de
Tel: +49 (0)176/81228565
Fax: +49 (0)7181/884765
Disposal
Electronic components do not belong in household waste, but
should be disposed of separately.
DOC-000044
DE
EN
Page 49