Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BSS-Streaming Service
Note: Never pull or
hold the controls of
the Flow 8 when re-
moving them, as this
could pull them off
their controls or
damage them.
Note: When remov-
ing the Flow 8, do
not pull on the USB
cable while it is still
plugged in. Other-
wise these or the
(Fig. 5) Remove the Flow 8; tip the case onto a soft surface and hold the
built-in sockets in the
Flow 8 with one hand to prevent it from tipping out
device may be dam-
aged.
Inserting the smartphone or tablet
Adjusting the holder
The holder can hold smartphones or
tablets up to a maximum size of 260 mm x
178.5 mm x 8.5 mm (WxHxD). Inserting
larger devices can lead to damage to the
holder and the device.
Before inserting the smartphone or
tablet, the lower and upper device
holder must be adjusted to the correct
size.
Adjust the lower holder
Open the eccentric lever on the lower bracket and adjust it to the desired height. Close the
lever to fix the position (Fig. 6).
Adjusting the upper holder
Open the eccentric lever on the upper holder and adjust the height so that it fits your
smartphone or tablet. Close the lever to fix the position.
Insert the device
Swivel your device into the lower holder.
Page
BSS-Flow 8 Case
(Fig. 6) Upper holder with open eccentric lever
Operating instruction EN
Adjust the upper holder
Push the spring-loaded pressure piece
on the upper holder upwards and
swivel your device into the holder. Al-
low the pressure piece to rest gently
against the device (Fig. 7).
Check the fit of the device
The device is ideally inserted when it
is held by the pressure piece with
maximum tension. Make sure that the
inserted device is completely inside
the holders of the upper and lower
holder. If this is not the case, repeat the adjustment process for the upper holder until
(Fig. 8) iPad inserted in the holder
the holder.
Note: only use one of the two charging cables at a time to charge an inserted device
Note: Remove plugs by pulling on the plugs or their strain relief and not by pulling the cables.
Otherwise they may be damaged.
Insert charging cable
The charging connection is plugged
in from the underside on devices that
have sufficient space to the edge of
the cover. In order to avoid bending
the cable too much, the connection
DOC-000044
(Fig. 7) Adjust the upper holder to the correct dis-
tance and apply the pressure piece
the device is optimally positioned. Your de-
vice is now securely fixed in the holder
(Fig. 8).
Note: If the device sits too loosely in the holder,
there is a risk of it coming loose from the
holder during operation or transportation and
being damaged.
Charging connection
There are two charging cables in the holder
in the top right-hand corner of the ceiling
for devices with USB-C and Lightning con-
nections (Bild 9). These can be removed
from the holder by pulling them downwards
and used to charge the devices inserted in
(Fig. 9) Charging cable in holder
DE
EN
Page 37
Werbung
