Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
COMPLEX RADIO CONTROL SYSTEM
selected output. Receiver output 1 is labeled as Y1.
Some of the receivers outputs may be assigned (see the table of
receiver output assignments) to alternative functions. Description
of alternative functions:
- standard servo output - the throw of an actual channel is assigned
to the output that uses the standard servo output form and is
labelled CH xx.
- PPM off - for the given output there is no PPM signal generated or
received
- PPM input - for the given input there a PPM signal is expected from
the connected receiver
- PPM output - the receiver channel will generate a PPM signal
PPM error code- in case one of the SAT1/2 outputs is set to PPM
input mode, an acoustic signal can be set up to announce that this
connected signal is missing. By loading a character from the Morse
alphabet you may set up tones that will acoustically announce the
absence of a PPM signal at the given receiver output. This acoustical
signal is generated by the transmitter module. In the factory default
setup the acoustical signal is switched off.
SetInChannel - assignment of an actual output (labelled as Yx) or
input channel (labelled as Chx)
Output Trim - neutral throw setup for receiver output
Gain A - amplification of the output throw in the negative half-plain
A (from -150 to 0%)
Gain B - amplification of the output throw in the positive half-plain
B (from 0% to 150%)
25
Werbung
